Chapter 37 DHCP
MES3500 Series User’s Guide
289
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click this to reset the values above based on the last selected entry or, if not applicable, to
clear the fields above.
Clear Click Clear to reset the fields to the factory defaults.
Index This field displays a sequential number for each entry. Click an index number to change the
settings.
VID This field displays the VLAN to which the port(s) belongs.
Port This field displays the port(s) to which the Switch applies the settings.
Profile Name This field displays the DHCPv6 options profile that the Switch applies to the specified
port(s) in this VLAN.
Delete Select the entry(ies) that you want to remove in the Delete column, then click the Delete
button to remove the selected entry(ies) from the table.
Cancel Click this to clear the check boxes in the Delete column.
Table 135 IP Application > DHCP > DHCPv6 > Port (continued)
LABEL DESCRIPTION
To Next Page
Loading...
