Chapter 4 The Web Configurator
MES3500 Series User’s Guide
39
AAA This link takes you to a screen where you can configure authentication, authorization and
accounting services via external servers. The external servers can be either RADIUS
(Remote Authentication Dial-In User Service) or TACACS+ (Terminal Access Controller
Access-Control System Plus).
IP Source Guard This link takes you to screens where you can configure filtering of unauthorized DHCP and
ARP packets in your network.
Loop Guard This link takes you to a screen where you can configure protection against network loops
that occur on the edge of your network.
VLAN Mapping This link takes you to screens where you can configure VLAN mapping settings on the
Switch.
Layer 2 Protocol
Tunneling
This link takes you to a screen where you can configure L2PT (Layer 2 Protocol Tunneling)
settings on the Switch.
sFlow This link takes you to screens where you can configure sFlow settings on the Switch.
PPPoE This link takes you to screens where you can configure how the Switch gives a PPPoE
termination server additional subscriber information that the server can use to identify
and authenticate a PPPoE client.
Errdisable This link takes you to a screen where you can configure CPU protection and error disable
recovery.
Private VLAN This link takes you to a screen where you can block traffic between ports in a VLAN on the
Switch.
IP Application
Static Routing This link takes you to a screen where you can configure static routes. A static route
defines how the Switch should forward traffic by configuring the TCP/IP parameters
manually.
DiffServ This link takes you to screens where you can enable DiffServ, configure marking rules and
set DSCP-to-IEEE802.1p mappings.
DHCP This link takes you to screens where you can configure the DHCP settings.
ARP Learning This link takes you to screens where you can configure the ARP learning settings for each
port.
Management
Maintenance This link takes you to screens where you can perform firmware and configuration file
maintenance as well as reboot the system.
Access Control This link takes you to screens where you can change the system login password and
configure SNMP and remote management.
Diagnostic This link takes you to screens where you can view system logs and can test port(s).
Syslog This link takes you to screens where you can setup system logs and a system log server.
Cluster
Management
This link takes you to a screen where you can configure clustering management and view
its status.
MAC Table This link takes you to a screen where you can view the MAC address and VLAN ID of a
device attached to a port. You can also view what kind of MAC address it is.
ARP Table This link takes you to a screen where you can view the MAC address – IP address
resolution table.
Configure Clone This link takes you to a screen where you can copy attributes of one port to (an)other
port(s).
Table 6 Navigation Panel Links (continued)
LINK DESCRIPTION
To Next Page
Loading...
Need help?
General
