Chapter 8 Network Address Translation (NAT)
P-792H v2 User’s Guide
108
To change your P-792H v2’s address mapping settings, click Network > NAT >
Address Mapping to open the following screen.
Figure 44 Network > NAT > Address Mapping
The following table describes the fields in this screen.
Table 26 Network > NAT > Address Mapping
LABEL DESCRIPTION
# This is the rule index number.
Local Start IP This is the starting Inside Local IP Address (ILA). Local IP addresses are
N/A for Server port mapping.
Local End IP This is the end Inside Local IP Address (ILA). If the rule is for all local IP
addresses, then this field displays 0.0.0.0 as the Local Start IP address
and 255.255.255.255 as the Local End IP address. This field is N/A for
One-to-one and Server mapping types.
Global Start
IP
This is the starting Inside Global IP Address (IGA). Enter 0.0.0.0 here if
you have a dynamic IP address from your ISP. You can only do this for
Many-to-One and Server mapping types.
Global End IP This is the ending Inside Global IP Address (IGA). This field is N/A for
One-to-one, Many-to-One and Server mapping types.
To Next Page
Loading...
