ZyXEL Communications P-792H - Address Mapping Sets

Chapter 30 NAT Setup
P-792H v2 User’s Guide
324
A server set is a list of LAN servers mapped to external ports. To use this set, a
server rule must be set up inside the NAT address mapping set. Please see the
section on port forwarding in Section 8.3 on page 104 for further information on
these menus. To configure NAT, enter 15 from the main menu to bring up the
following screen.
Figure 155 Menu 15: NAT Setup
30.2.1 Address Mapping Sets
Enter 1 to bring up Menu 15.1.1 - Address Mapping Sets.
Figure 156 Menu 15.1: Address Mapping Sets
Select the address mapping set you want to modify. The fields in address 255 are
used for SUA and are read-only.
Menu 15 - NAT Setup
1. Address Mapping Sets
2. NAT Server Sets
Menu 15.1 - Address Mapping Sets
1. ACL Default Set
2.
3.
4.
5.
6.
7.
8.
255. SUA (read only)