ZyXEL Communications P-792H - Set up the Server

Chapter 5 Tutorial
P-792H v2 User’s Guide
54
3 Connect the P-792H v2s.
5.2.1 Set Up the Server
1 Log in to the server P-792H v2 of Company A.
2 Click Network > WAN > Internet Access Setup.
3 Configure the Internet Access Setup screen as the following. Select ATM as the
Transfer Mode. Select Bridge as the Mode. Configure the Multiplexing,
Encapsulation, VPI, and VCI fields for the point-to-point connection. Select 1
in the Line field as the DSL line you want the P-792H v2 to use as a default for
outgoing traffic.
4 Then configure the Service Type section. The Service Mode is 2 wire. In the
Service Type field, select Server. Select 5696 as the Transfer Max Rate and
3200 as the Transfer Min Rate. Leave the rest of the fields set to their default
settings. Click Apply.
Figure 22 WAN > Internet Access Setup