Chapter 28 Remote Node Setup
P-792H v2 User’s Guide
308
28.3 Remote Node Profile
The following explains how to configure remote nodes 1-7.
Figure 144 Menu 11.1: Remote Node Profile (nodes 1-7)
The following table describes the labels in this menu.
Menu 11.1 - Remote Node Profile
Rem Node Name= MyISP Route= IP
Active= Yes Bridge= No
Encapsulation= PPPoE Edit IP/Bridge= No
Multiplexing= LLC-based Edit ATM/PTM Options= No
Service Name= Edit Advance Options= No
Incoming: Telco Option:
Rem Login= Allocated Budget(min)= 0
Rem Password= ******** Period(hr)= 0
Outgoing: Schedule Sets=
My Login= Nailed-Up Connection= No
My Password= ******** Session Options:
Authen= CHAP/PAP Edit Filter Sets= No
Idle Timeout(sec)= 0
Table 115 Menu 11.1: Remote Node Profile (nodes 1-7)
FIELD DESCRIPTION
Rem Node Name Enter the name of the ISP.
Active Select whether or not you want to use this Internet connection.
Encapsulation Select the type of encapsulation your ISP uses: PPPoE, RFC 1483,
PPPoA, or ENET ENCAP.
Multiplexing Select the method of multiplexing used by your ISP from the drop-
down list. Choices are VC-based or LLC-based.
Service Name (PPPoE only) Enter the service name provided by your ISP. Leave
this field blank if your ISP did not provide one.
Incoming This section is only enabled for PPPoA or PPPoE connections.
Rem Login Type the login name that this remote node will use to call your P-
792H v2. The login name and the Rem Password will be used to
authenticate this node.
Rem Password Type the password used when this remote node calls your P-792H
v2.
Outgoing This section is only enabled for PPPoA or PPPoE connections.
My Login Enter the user name provided by your ISP.
My Password Enter the password provided by your ISP.
Retype to Confirm Enter the password again.
To Next Page
Loading...
