Chapter 30 NAT Setup
P-792H v2 User’s Guide
328
3 Enter 1 to configure the server set used by SUA, or enter the number of the server
set you want to modify for full-feature NAT. In Menu 15.2 - NAT Server Setup,
configure the port forwarding rules.
Figure 160 Menu 15.2: NAT Server Setup
The first entry is for the Default Server. The following table describes the labels in
this menu.
30.4 General NAT Examples
The following are some examples of NAT configuration.
Menu 15.2 - NAT Server Setup
Rule Start Port No. End Port No. IP Address
---------------------------------------------------
1. Default Default 0.0.0.0
2. 80 80 192.168.1.10
3. 0 0 0.0.0.0
4. 0 0 0.0.0.0
5. 0 0 0.0.0.0
6. 0 0 0.0.0.0
7. 0 0 0.0.0.0
8. 0 0 0.0.0.0
9. 0 0 0.0.0.0
10. 0 0 0.0.0.0
11. 0 0 0.0.0.0
12. 0 0 0.0.0.0
Table 125 Menu 15.2: NAT Server Setup
FIELD DESCRIPTION
Rule This field is a sequential value, and it is not associated with a specific
rule. The sequence is important, however. The P-792H v2 checks
each active rule in order, and it only follows the first one that applies.
Start Port This field displays the beginning of the range of port numbers
forwarded by this rule.
End Port This field displays the end of the range of port numbers forwarded by
this rule. If it is the same as the Start Port, only one port number is
forwarded.
IP Address This field displays the IP address of the server to which packet for
the selected port(s) are forwarded.
To Next Page
Loading...
