Chapter 17 Remote Management
P-792H v2 User’s Guide
232
17.6 The DNS Screen
Use DNS (Domain Name System) to map a domain name to its corresponding IP
address and vice versa. Refer to Chapter 7 on page 85 for background
information.
Use this screen to set from which IP address the P-792H v2 will accept DNS
queries and on which interface it can send them your P-792H v2’s DNS settings.
This feature is not available when the P-792H v2 is set to bridge mode. Click
Advanced > Remote MGMT > DNS to change your P-792H v2’s DNS settings.
Figure 108 Advanced > Remote Management > DNS
The following table describes the labels in this screen.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Table 73 Advanced > Remote Management > SNMP
LABEL DESCRIPTION
Table 74 Advanced > Remote Management > DNS
LABEL DESCRIPTION
Port The DNS service port number is 53 and cannot be changed here.
Access Status Select the interface(s) through which a computer may send DNS queries
to the P-792H v2.
Secured Client
IP
A secured client is a “trusted” computer that is allowed to send DNS
queries to the P-792H v2.
Select All to allow any computer to send DNS queries to the P-792H v2.
Choose Selected to just allow the computer with the IP address that
you specify to send DNS queries to the P-792H v2.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
