Chapter 35 Firmware and Configuration File Maintenance
P-792H v2 User’s Guide
375
2 The following screen indicates that the Xmodem download has started.
Figure 201 System Maintenance: Starting Xmodem Download Screen
3 Run the HyperTerminal program by clicking Transfer, then Receive File as shown
in the following screen.
Figure 202 Backup Configuration Example
Type a location for storing the configuration file or click Browse to look for one.
Choose the Xmodem protocol.
Then click Receive.
4 After a successful backup you will see the following screen. Press any key to
return to the SMT menu.
Figure 203 Successful Backup Confirmation Screen
35.4 Restore Configuration
This section shows you how to restore a previously saved configuration. Note that
this function erases the current configuration before restoring a previous back up
configuration; please do not attempt to restore unless you have a backup
configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to
your P-792H v2 since FTP is faster. Please note that you must wait for the system
to automatically restart after the file transfer is complete.
You can enter ctrl-x to terminate operation any time.
Starting XMODEM download...
** Backup Configuration completed. OK.
### Hit any key to continue.###
To Next Page
Loading...
