ZyXEL Communications P-792H - Applying Remote Node Filters

Chapter 32 Filter Configuration
P-792H v2 User’s Guide
353
example 3, 4, 6, 11. Input filter sets filter incoming traffic to the P-792H v2 and
output filter sets filter outgoing traffic from the P-792H v2.
Figure 186 Filtering LAN Traffic
32.6.2 Applying Remote Node Filters
Go to menu 11.5 (shown below – note that call filter sets are only present for
PPPoA or PPPoE encapsulation) and enter the number(s) of the filter set(s) as
appropriate. You can cascade up to four filter sets by entering their numbers
separated by commas. The P-792H v2 already has filters to prevent NetBIOS
traffic from triggering calls, and block incoming telnet, FTP and HTTP connections.
Figure 187 Filtering Remote Node Traffic
Menu 3.1 - LAN Port Filter Setup
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=