Chapter 30 NAT Setup
P-792H v2 User’s Guide
322
30.1.2 Applying NAT
You apply NAT via menus 4 or 11.3 as displayed next. The next figure shows you
how to apply NAT for Internet access in menu 4. Enter 4 from the main menu to
go to Menu 4 - Internet Access Setup.
Figure 153 Menu 4: Applying NAT for Internet Access
The following figure shows how you apply NAT to the remote node in menu 11.3.
1 Enter 11 from the main menu.
2 Enter 1 to open Menu 11.1 - Remote Node Profile.
Menu 4 - Internet Access Setup
ISP's Name= MyISP
Encapsulation= ENET ENCAP
Multiplexing= LLC-based
VPI #= 0
VCI #= 33
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
My Login= N/A
My Password= N/A
ENET ENCAP Gateway= 0.0.0.0
IP Address Assignment= Static
IP Address= 0.0.0.0
Network Address Translation= SUA Only
Address Mapping Set= N/A
To Next Page
Loading...
