ZyXEL Communications P-792H - Example Xmodem Firmware Upload Using Hyperterminal; Uploading Configuration File Via Console Port

Chapter 35 Firmware and Configuration File Maintenance
P-792H v2 User’s Guide
383
35.5.9 Example Xmodem Firmware Upload Using
HyperTerminal
Click Transfer, then Send File to display the following screen.
Figure 214 Example Xmodem Upload
After the firmware upload process has completed, the P-792H v2 will
automatically restart.
35.5.10 Uploading Configuration File Via Console Port
1 Select 2 from Menu 24.7 – System Maintenance – Upload Firmware to display
Menu 24.7.2 - System Maintenance - Upload System Configuration File. Follow the
instructions as shown in the next screen.
Figure 215 Menu 24.7.2 As Seen Using the Console Port
Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload system configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart
the system.
Warning:
1. Proceeding with the upload will erase the current
configuration file.
2. The system's console port speed (Menu 24.2.2) may change when it is
restarted; please adjust your terminal's speed accordingly. The password
may change (menu 23), also.
3. When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the password to "1234".
Do You Wish To Proceed:(Y/N)