ZyXEL Communications P-792H - Command Usage; Call Control Support

Chapter 36 Menus 24.8 to 24.11
P-792H v2 User’s Guide
386
The required fields in a command are enclosed in angle brackets <>.
The optional fields in a command are enclosed in square brackets [].
The |symbol means “or”.
For example,
sys filter netbios config <type> <on|off>
means that you must specify the type of netbios filter and whether to turn it on or
off.
36.1.2 Command Usage
A list of commands can be found by typing help or ? at the command prompt.
Always type the full command. Type exit to return to the SMT main menu when
finished.
Figure 218 Valid Commands
36.2 Call Control Support
The P-792H v2 provides a call control function for budget management. Please
note that this menu is only applicable when Encapsulation is set to PPPoE or
PPPoA in menu 4 or menu 11.1.
The budget management function allows you to set a limit on the total outgoing
call time of the P-792H v2 within certain times. When the total outgoing call time
exceeds the limit, the current call will be dropped and any future outgoing calls
will be blocked.
Call history chronicles preceding incoming and outgoing calls.
Valid commands are:
sys exit device ether
wan poe xdsl aux
config ip ipsec ppp
bridge hdap bm lan
P-792H v2>