Chapter 30 NAT Setup
P-792H v2 User’s Guide
329
30.4.1 Internet Access Only
In the following Internet access example, you only need one rule where all your
ILAs (Inside Local addresses) map to one dynamic IGA (Inside Global Address)
assigned by your ISP.
Figure 161 NAT Example 1
Figure 162 Menu 4: Internet Access & NAT Example
From menu 4 shown above, simply choose the SUA Only option from the Network
Address Translation field. This is the Many-to-One mapping discussed in Section
30.4 on page 328. The SUA Only read-only option from the Network Address
Translation field in menus 4 and 11.3 is specifically pre-configured to handle this
case.
Menu 4 - Internet Access Setup
ISP's Name= MyISP
Encapsulation= ENET ENCAP
Multiplexing= LLC-based
VPI #= 0
VCI #= 33
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
My Login= N/A
My Password= N/A
ENET ENCAP Gateway= 0.0.0.0
IP Address Assignment= Static
IP Address= 0.0.0.0
Network Address Translation= SUA Only
Address Mapping Set= N/A
To Next Page
Loading...
