Chapter 34 System Information & Diagnosis
P-792H v2 User’s Guide
362
Examples of typical error and information messages are presented in the following
figure.
Figure 195 Examples of Error and Information Messages
34.4.2 Syslog Logging
The P-792H v2 uses the syslog facility to log the CDR (Call Detail Record) and
system messages to a syslog server. Syslog and accounting can be configured in
Menu 24.3.2 - System Maintenance - Syslog Logging, as shown next.
Figure 196 Menu 24.3.2: System Maintenance - UNIX Syslog
You need to configure the syslog parameters described in the following table to
activate syslog then choose what you want to log.
34 Sat Jan 1 00:00:02 2000 PP05 -WARN SNMP TRAP 3: link up
35 Sat Jan 1 00:00:04 2000 PP00 INFO Channel 0 ok
36 Sat Jan 1 00:00:06 2000 PP0c INFO LAN promiscuous mode <0>
37 Sat Jan 1 00:00:06 2000 PP00 -WARN SNMP TRAP 0: cold start
38 Sat Jan 1 00:00:06 2000 PP00 INFO main: init completed
39 Sat Jan 1 00:00:06 2000 PP00 INFO Starting Connectivity Monitor
40 Sat Jan 1 00:00:06 2000 PP18 INFO adjtime task pause 1 day
41 Sat Jan 1 00:00:06 2000 PP19 INFO monitoring WAN connectivity
42 Sat Jan 1 00:00:06 2000 PP06 WARN MPOA Link Down
43 Sat Jan 1 04:10:22 2000 PP0c WARN netMakeChannDial: err=-3001
44 Sat Jan 1 04:10:42 2000 PP10 WARN Last errorlog repeat 18 Times
45 Sat Jan 1 04:10:42 2000 PP10 INFO SMT Password pass
46 Sat Jan 1 04:10:42 2000 PP00 INFO SMT Session Begin
47 Sat Jan 1 04:10:44 2000 PP0c WARN netMakeChannDial: err=-3001
48 Sat Jan 1 04:46:08 2000 PP00 WARN Last errorlog repeat 216 Times
49 Sat Jan 1 04:46:08 2000 PP00 INFO SMT Session End
51 Sat Jan 1 04:46:59 2000 PP0c WARN netMakeChannDial: err=-3001
52 Sat Jan 1 04:58:00 2000 PP10 WARN Last errorlog repeat 65 Times
53 Sat Jan 1 04:58:00 2000 PP10 INFO SMT Password pass
Clear Error Log (y/n):
Menu 24.3.2 - System Maintenance - UNIX Syslog
UNIX Syslog:
Active= No
Syslog IP Address= 0.0.0.0
Log Facility= Local 1
Table 133 Menu 24.3.2: System Maintenance - UNIX Syslog
FIELD DESCRIPTION
UNIX Syslog:
Active Press [SPACE BAR] and then [ENTER] to turn syslog on or off.
To Next Page
Loading...
