Chapter 17 Remote Management
P-792H v2 User’s Guide
226
The following table describes the labels in this screen.
17.3 The Telnet Screen
You can use Telnet to access the P-792H v2’s command line interface. Specify
which interfaces allow Telnet access and from which IP address the access can
come.
Click Advanced > Remote MGMT > Telnet tab to display the screen as shown.
Figure 104 Advanced > Remote Management > Telnet
Table 69 Advanced > Remote Management > WWW
LABEL DESCRIPTION
Port You may change the server port number for a service, if needed.
However, you must use the same port number in order to use that
service for remote management.
Access Status Select the interface(s) through which a computer may access the P-
792H v2 using this service.
Secured Client
IP
A secured client is a “trusted” computer that is allowed to communicate
with the P-792H v2 using this service.
Select All to allow any computer to access the P-792H v2 using this
service.
Choose Selected to just allow the computer with the IP address that
you specify to access the P-792H v2 using this service.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
