P-792H v2 User’s Guide
303
CHAPTER 27
Internet Access Setup
Use this menu to configure your Internet connection. Use information from your
ISP along with the instructions in this chapter to set up your P-792H v2 to access
the Internet. Contact your ISP to determine what encapsulation type you should
use.
27.1 Internet Access Setup
Enter 4 in the main menu.
Figure 142 Menu 4: Internet Access Setup
The following table describes the fields in this menu.
Menu 4 - Internet Access Setup
ISP's Name= MyISP
Encapsulation= ENET ENCAP
Multiplexing= LLC-based
VPI #= 0
VCI #= 33
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
My Login= N/A
My Password= N/A
ENET ENCAP Gateway= 0.0.0.0
IP Address Assignment= Static
IP Address= 0.0.0.0
Network Address Translation= SUA Only
Address Mapping Set= N/A
Table 114 Menu 4: Internet Access Setup
FIELD DESCRIPTION
ISP’s Name Enter a descriptive name for your ISP for identification purposes.
Encapsulation Press [SPACE BAR] and then press [ENTER] to select the type of
encapsulation your ISP uses.
To Next Page
Loading...
