ZyXEL Communications P-792H - Example of FTP Commands from the Command Line; GUI-Based FTP Clients; File Maintenance over WAN

Chapter 35 Firmware and Configuration File Maintenance
P-792H v2 User’s Guide
372
35.3.3 Example of FTP Commands from the Command Line
Figure 199 FTP Session Example
35.3.4 GUI-based FTP Clients
The following table describes some of the commands that you may see in GUI-
based FTP clients.
35.3.5 File Maintenance Over WAN
TFTP, FTP and Telnet over the WAN will not work when:
1 The firewall is active (turn the firewall off in menu 21.2 or create a firewall rule to
allow access from the WAN).
2 You have disabled Telnet service in menu 24.11.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
Table 136 General Commands for GUI-based FTP Clients
COMMAND DESCRIPTION
Host Address Enter the address of the host server.
Login Type Anonymous.
This is when a user I.D. and password is automatically supplied to
the server for anonymous access. Anonymous logins will work only
if your ISP or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer Type Transfer files in either ASCII (plain text format) or in binary mode.
Configuration and firmware files should be transferred in binary
mode
Initial Remote
Directory
Specify the default remote directory (path).
Initial Local Directory Specify the default local directory (path).