Chapter 13 Static Route
P-792H v2 User’s Guide
189
13.2.1 Static Route Edit
Use this screen to configure the required information for a static route. Select a
static route index number and click Edit. The screen shown next appears.
Figure 87 Advanced > Static Route: Edit
The following table describes the labels in this screen.
Table 58 Advanced > Static Route: Edit
LABEL DESCRIPTION
Active This field allows you to activate/deactivate this static route.
Route Name Enter the name of the IP static route. The text may consist of up to 9
letters, numerals and any printable character found on a typical English
language keyboard. Leave this field blank to delete this static route.
Destination IP
Address
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host
ID.
IP Subnet
Mask
Enter the IP subnet mask here.
Gateway Type Use either Gateway Address or Gateway Node to configure a static
route.
Gateway IP
Address
Enter the IP address of the gateway. The gateway is a router or switch on
the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
Gateway Node This field is available when you select Gateway Node from Gateway
Type.
Select a remote node to set the static route. A remote note is a
connection point outside of the local area network. One example of a
remote node is your connection to your ISP.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
