Chapter 17 Remote Management
P-792H v2 User’s Guide
225
• There is already another remote management session with an equal or higher
priority running. You may only have one remote management session running
at one time.
• There is a firewall rule that blocks it.
Remote Management and NAT
When NAT is enabled:
• Use the P-792H v2’s WAN IP address when configuring from the WAN.
• Use the P-792H v2’s LAN IP address when configuring from the LAN.
System Timeout
There is a default system management idle timeout of five minutes (three
hundred seconds). The P-792H v2 automatically logs you out if the management
session remains idle for longer than this timeout period. The management session
does not time out when a statistics screen is polling.
17.2 The WWW Screen
Use this screen to specify how to connect to the P-792H v2 from a web browser,
such as Internet Explorer. You can also specify which IP addresses the access can
come from.
Note: If you disable the WWW service in this screen, then the P-792H v2 blocks all
HTTP connection attempts.
17.2.1 Configuring the WWW Screen
Click Advanced > Remote MGMT to display the WWW screen.
Figure 103 Advanced > Remote Management > WWW
To Next Page
Loading...
