Chapter 35 Firmware and Configuration File Maintenance
P-792H v2 User’s Guide
380
35.5.3 FTP File Upload Command from the DOS Prompt
Example
1 Launch the FTP client on your computer.
2 Enter “open”, followed by a space and the IP address of your P-792H v2.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is “1234”).
5 Enter “bin” to set transfer mode to binary.
6 Use “put” to transfer files from the computer to the P-792H v2, for example, “put
firmware.bin ras” transfers the firmware on your computer (firmware.bin) to the
P-792H v2 and renames it “ras”. Similarly, “put config.rom rom-0” transfers the
configuration file on your computer (config.rom) to the P-792H v2 and renames it
“rom-0”. Likewise “get rom-0 config.rom” transfers the configuration file on the P-
792H v2 to your computer and renames it “config.rom.” See earlier in this chapter
for more information on filename conventions.
7 Enter “quit” to exit the ftp prompt.
35.5.4 FTP Session Example of Firmware File Upload
Figure 212 FTP Session Example of Firmware File Upload
More commands (found in GUI-based FTP clients) are listed earlier in this chapter.
Refer to Section 35.3.5 on page 372 to read about configurations that disallow
TFTP and FTP over WAN.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
To Next Page
Loading...
