ZyXEL Communications P-792H - Configuring the LAN IP Alias Screen

Chapter 7 LAN Setup
P-792H v2 User’s Guide
94
7.5.1 Configuring the LAN IP Alias Screen
Use this screen to change your P-792H v2’s IP alias settings. Click Network >
LAN > IP Alias to open the following screen.
Figure 38 Network > LAN > IP Alias
The following table describes the labels in this screen.
Table 22 Network > LAN > IP Alias
LABEL DESCRIPTION
IP Alias 1, 2 Select the check box to configure another LAN network for the P-792H
v2.
IP Address Enter the IP address of your P-792H v2 in dotted decimal notation.
Alternatively, click the right mouse button to copy and/or paste the IP
address.
IP Subnet Mask Your P-792H v2 will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the P-792H v2.
RIP Direction RIP (Routing Information Protocol, RFC 1058 and RFC 1389) allows a
router to exchange routing information with other routers. The RIP
Direction field controls the sending and receiving of RIP packets.
Select the RIP direction from Both/In Only/Out Only/None. When
set to Both or Out Only, the P-792H v2 will broadcast its routing table
periodically. When set to Both or In Only, it will incorporate the RIP
information that it receives; when set to None, it will not send any RIP
packets and will ignore any RIP packets received.