ZyXEL Communications P-792H - TCP;IP and DHCP Setup Menu

Chapter 26 LAN Setup
P-792H v2 User’s Guide
300
26.3 TCP/IP and DHCP Setup Menu
From the main menu, enter 3 to open Menu 3 - LAN Setup to configure TCP/IP
(RFC 1155) and DHCP setup. From menu 3, select the submenu option TCP/IP
and DHCP Setup and press [ENTER]. The screen now displays
Menu 3.2 - TCP/
IP and DHCP Ethernet Setup
, as shown next. Not all fields are available on all
models.
Figure 140 Menu 3.2: TCP/IP and DHCP Ethernet Setup
Follow the instructions in the next table to configure these fields.
Menu 3.2 - TCP/IP and DHCP Setup
DHCP= Server
Client IP Pool Starting Address= 192.168.1.33
Size of Client IP Pool= 32
First DNS Server= 0.0.0.0
Secondary DNS Server= 0.0.0.0
Third DNS Server= 0.0.0.0
DHCP Server Address= N/A
TCP/IP Setup:
IP Address= 192.168.1.1
IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version= RIP-2B
Multicast= IGMP-v2
IP Policies=
Edit IP Alias= No
Table 112 Menu 3.2: TCP/IP and DHCP Ethernet Setup
FIELD DESCRIPTION
DHCP Setup
DHCP This field enables/disables the DHCP server.
If set to Server, your P-792H v2 will act as a DHCP server. You should
configure the rest of the fields in this section except for Remote DHCP
Server.
If set to Relay, the P-792H v2 acts as a surrogate DHCP server and
relays requests and responses between the remote server and the
clients. The Remote DHCP Server needs to be set.
If set to None, the DHCP server will be disabled.
Client IP Pool
Starting
Address:
This field specifies the first of the contiguous addresses in the IP address
pool.
Size of Client
IP Pool
This field specifies the size, or count of the IP address pool.