Chapter 34 System Information & Diagnosis
P-792H v2 User’s Guide
359
34.3 System Information and Console Port
Speed
This section describes your system and allows you to choose different console port
speeds. To get to the System Information and Console Port Speed:
1 Enter 24 to go to Menu 24 - System Maintenance.
2 Enter 2 to open Menu 24.2 - System Information and Console Port Speed.
3 From this menu you have two choices as shown in the next figure:
Figure 191 Menu 24.2: System Information and Console Port Speed
Errors This is the number of error packets on this connection.
Tx B/s This field shows the transmission rate in bytes per second on this port.
Rx B/s This field shows the reception rate in bytes per second on this port.
Up Time This is the total amount of time the this channel has been connected to
the remote node.
My WAN IP
(from ISP)
This is the IP address assigned by your ISP or the static IP address you
set up in menu 4.
Ethernet: This section displays information about the LAN ports.
Status This field displays the speed and duplex settings of the LAN ports.
Collisions This is the number of collisions on this port.
TxPkts This is the number of transmitted packets on this port.
RxPkts This is the number of received packets on this port.
WAN This section displays information about the WAN port.
Line Status This field displays the port speed and duplex setting if you’re using
Ethernet encapsulation and Down (line is down or not connected), Idle
(line (ppp) idle), Dial (starting to trigger a call) or Drop (dropping a
call) if you’re using PPPoE encapsulation.
Transfer Rate This field shows the transmission speed in kilobits per second on this
port.
CPU Load This field displays the percentage of CPU utilization.
You may enter 1 to reset the counters or [ESC] to return to menu 24.
Table 131 Menu 24.1: System Maintenance - Status (continued)
FIELD DESCRIPTION
Menu 24.2 - System Information and Console Port Speed
1. System Information
2. Console Port Speed
To Next Page
Loading...
