Chapter 34 System Information & Diagnosis
P-792H v2 User’s Guide
358
To get to the System Status:
1 Enter number 24 to go to Menu 24 - System Maintenance.
2 In this menu, enter 1 to open System Maintenance - Status.
3 There are three commands in Menu 24.1 - System Maintenance - Status.
Entering 1 drops the WAN connection, 9 resets the counters and [ESC] takes you
back to the previous screen.
Figure 190 Menu 24.1: System Maintenance - Status
The following table describes the fields present in Menu 24.1 - System
Maintenance - Status. These fields are read-only and meant for diagnostic
purposes. The upper right corner of the screen shows the time and date.
Menu 24.1 - System Maintenance - Status 06:28:45
Sat. Jan. 01, 2000
Node-Lnk Status TxPkts RxPkts Errors Tx B/s Rx B/s Up Time
1-ENET N/A 0 0 0 0 0 0:00:00
2 N/A 0 0 0 0 0 0:00:00
3 N/A 0 0 0 0 0 0:00:00
4 N/A 0 0 0 0 0 0:00:00
5 N/A 0 0 0 0 0 0:00:00
6 N/A 0 0 0 0 0 0:00:00
7 N/A 0 0 0 0 0 0:00:00
8 N/A 0 0 0 0 0 0:00:00
My WAN IP (from ISP): 0.0.0.0
Ethernet: WAN:
Status: 100M/Full Duplex Tx Pkts: 4210 Line Status: Down
Collisions: 0 Rx Pkts: 4466 Transfer Rate: 0 kbps
CPU Load = 1.27%
Press Command:
COMMANDS: 1-Reset Counters ESC-Exit
Table 131 Menu 24.1: System Maintenance - Status
FIELD DESCRIPTION
Node-Lnk This field is the remote node index number and link type
(encapsulation).
Status This field displays Down (line is down), Up (line is up or connected) if
you're using Ethernet encapsulation and Down (line is down), Up (line
is up or connected), Idle (line (ppp) idle), Dial (starting to trigger a
call) and Drop (dropping a call) if you're using PPPoE encapsulation. It
displays N/A if the port is not connected.
TxPkts This is the number of packets transmitted from the P-792H v2 to the
remote node.
RxPkts This is the number of packets received by the P-792H v2 from the
remote node.
To Next Page
Loading...
