Chapter 23 Introducing the SMT
P-792H v2 User’s Guide
286
Note: Use menu 23.1 to change the password.
Figure 133 SMT Main Menu
Note: There is an inactivity timeout, and the default value is ten minutes. If there is no
activity for longer than this, your P-792H v2 will automatically log you out. You
will then have to telnet into the P-792H v2 again. You can use the web
configurator or the CI commands (menu 24.8) to change the inactivity timeout
period.
23.2 SMT Menu Items
The following table provides an overview of each menu item.
Getting Started Advanced Management
1. General Setup 21. Filter and Firewall Setup
2. WAN Setup 22. SNMP Configuration
3. LAN Setup 23. System Password
4. Internet Access Setup 24. System Maintenance
Advanced Applications 26. Schedule Setup
11. Remote Node Setup
12. Static Routing Setup
15. NAT Setup 99. Exit
Enter Menu Selection Number:
Table 105 Main Menu Summary
MENU FUNCTION
1 General Setup Use this menu to set up device mode, dynamic DNS and
administrative information.
2 WAN Setup Use this menu to configure the DSL connection, and traffic
redirect interface.
3 LAN Setup Use this to apply LAN filters, configure LAN DHCP and TCP/IP
settings, and to allow or block layer-2 traffic between each pair of
ports.
4 Internet Access
Setup
Use this menu to configure your Internet connection.
11 Remote Node
Setup
Use this menu to configure detailed remote node settings (for
example, your ISP is a remote node) as well as apply filters.
To Next Page
Loading...
