ZyXEL Communications P-792H - Page 287

Chapter 23 Introducing the SMT
P-792H v2 User’s Guide
287
The following table gives you an overview of the various SMT menus.
11 Remote Node
Setup
Use this menu to configure detailed remote node settings (for
example, your ISP is a remote node) as well as apply filters.
12 Static Routing
Setup
Use this menu to configure IP and bridge (MAC) static routes.
15 NAT Setup Use this menu to configure Network Address Translation (NAT) on
the P-792H v2.
21 Filter and Firewall
Setup
Use this menu to configure filters and to activate or deactivate the
firewall.
22 SNMP
Configuration
Use this menu to configure SNMP.
23 System Password Use this menu to change your password.
24 System
Maintenance
Use this menu for comprehensive system maintenance, from
looking at the system status to uploading firmware. You can also
access the Command Interface (CI).
26 Schedule Setup Use this menu to configure schedule sets.
99 Exit Use this menu to exit the SMT.
Table 105 Main Menu Summary
MENU FUNCTION
Table 106 SMT Menus Overview
MENUS SUB MENUS
1 General Setup 1.1 Configure Dynamic
DNS
2 WAN Setup 2.1 Traffic Redirect Setup
3 LAN Setup 3.1 LAN Port Filter Setup
3.2 TCP/IP and DHCP
Setup
3.2.1 IP Alias Setup
4 Internet Access
Setup
11 Remote Node
Setup
11.1 Remote Node Profile 11.1.3 Remote Node
Network Layer Options
11.1.5 Remote Node Filter
11.1.6 Remote Node ATM
Layer Options
12 Static Route
Setup
12.1 IP Static Route Setup 12.1.1 Edit IP Static
Route
12.3 Bridge Static Route
Setup
12.3.1 Edit Bridge Static
Route
15 NAT Setup 15.1 Address Mapping Sets 15.1.x Address Mapping
Rules
15.1.x.x Address
Mapping Rule
15.2 NAT Server Sets 15.2.x NAT Server Setup