ZyXEL Communications P-792H - Remote Node Network Layer Options

Chapter 28 Remote Node Setup
P-792H v2 User’s Guide
310
28.4 Remote Node Network Layer Options
Move the cursor to the Edit IP/Bridge field in menu 11.1, then press [SPACE
BAR] to select Yes. Press [ENTER]
to open Menu 11.3 - Remote Node Network
Layer Options.
Figure 145 Menu 11.3: Remote Node Network Layer Options
The following table describes the fields in this menu.
Edit Filter Sets If you want to specify input and output filter sets for the WAN port,
press [SPACE BAR] to select Yes and press [ENTER]. Menu 11.5
appears.
Idle Timeout(sec) Enter the number of seconds the P-792H v2 should wait while there
is no Internet traffic before it automatically disconnects from the ISP.
Enter a time interval between 10 and 9999 seconds.
Table 115 Menu 11.1: Remote Node Profile (nodes 1-7) (continued)
FIELD DESCRIPTION
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment = Static Ethernet Addr Timeout(min)= N/A
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= None
IP Policies=
Table 116 Menu 11.3: Remote Node Network Layer Options
FIELD DESCRIPTION
IP Address
Assignment
Select Dynamic if your ISP did not give you a fixed (static) IP
address. Select Static if your ISP gave you a fixed (static) IP
address. The next three fields are not available if you select
Dynamic.
Rem IP Addr Enter the IP address of the remote (peer) computer to which the P-
792H v2 connects.
Rem Subnet Mask Enter the subnet mask of the remote (peer) computer to which the
P-792H v2 connects.
My WAN Addr Enter the fixed (static) IP address provided by your ISP.