Chapter 28 Remote Node Setup
P-792H v2 User’s Guide
311
NAT Select None if you do not want to use port forwarding, trigger ports,
or NAT.
Select SUA Only if you want to use one or more of these features
and have only one WAN IP address for your P-792H v2.
Select Full Feature if you want to use one or more of these features
and have more than one public WAN IP address for your P-792H v2.
Address Mapping
Set
This field is enabled if NAT is Full Feature. Specify which address
mapping set you want to use for this remote node.
Metric This field sets this route's priority among the routes the P-792H v2
uses.
The metric represents the "cost of transmission". A router
determines the best route for transmission by choosing a path with
the lowest "cost". RIP routing uses hop count as the measurement of
cost, with a minimum of "1" for directly connected networks. The
number must be between "1" and "15"; a number greater than "15"
means the link is down. The smaller the number, the lower the
"cost".
Private This field is related to RIP. This field determines whether or not the
P-792H v2 includes the route to this remote node in its RIP
broadcasts. If you select Yes, this route is not included in RIP
broadcast. If you select No, the route to this remote node is
propagated to other hosts through RIP broadcasts. Usually, you
should keep the default value.
RIP Direction Use this field to control how much routing information the P-792H v2
sends and receives through this connection.
None - The P-792H v2 does not send or receive routing information
through this connection.
Both - The P-792H v2 sends and receives routing information
through this connection.
In Only - The P-792H v2 only receives routing information through
this connection.
Out Only - The P-792H v2 only sends routing information through
this connection.
Version Select which version of RIP the P-792H v2 uses when it sends or
receives information on the subnet.
RIP-1 - The P-792H v2 uses RIPv1 to exchange routing information.
RIP-2B - The P-792H v2 broadcasts RIPv2 to exchange routing
information.
RIP-2M - The P-792H v2 multicasts RIPv2 to exchange routing
information.
Table 116 Menu 11.3: Remote Node Network Layer Options (continued)
FIELD DESCRIPTION
To Next Page
Loading...
