Chapter 17 Remote Management
P-792H v2 User’s Guide
227
The following table describes the labels in this screen.
17.4 The FTP Screen
You can use FTP (File Transfer Protocol) to upload and download the P-792H v2’s
firmware and configuration files. Please see the User’s Guide chapter on firmware
and configuration file maintenance for details. To use this feature, your computer
must have an FTP client.
Use this screen to specify which interfaces allow FTP access and from which IP
address the access can come. To change your P-792H v2’s FTP settings, click
Advanced > Remote MGMT > FTP. The screen appears as shown.
Figure 105 Advanced > Remote Management > FTP
Table 70 Advanced > Remote Management > Telnet
LABEL DESCRIPTION
Port You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Access Status Select the interface(s) through which a computer may access the P-
792H v2 using this service.
Secured Client
IP
A secured client is a “trusted” computer that is allowed to communicate
with the P-792H v2 using this service.
Select All to allow any computer to access the P-792H v2 using this
service.
Choose Selected to just allow the computer with the IP address that you
specify to access the P-792H v2 using this service.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
