Chapter 17 Remote Management
P-792H v2 User’s Guide
231
17.5.3 Configuring SNMP
To change your P-792H v2’s SNMP settings, click Advanced > Remote MGMT >
SNMP. The screen appears as shown.
Figure 107 Advanced > Remote Management > SNMP
The following table describes the labels in this screen.
Table 73 Advanced > Remote Management > SNMP
LABEL DESCRIPTION
SNMP
Port You may change the server port number for a service, if needed.
However, you must use the same port number in order to use that
service for remote management.
Access Status Select the interface(s) through which a computer may access the P-
792H v2 using this service.
Secured Client IP A secured client is a “trusted” computer that is allowed to
communicate with the P-792H v2 using this service.
Select All to allow any computer to access the P-792H v2 using this
service.
Choose Selected to just allow the computer with the IP address that
you specify to access the P-792H v2 using this service.
SNMP Configuration
Get Community Enter the Get Community, which is the password for the incoming
Get and GetNext requests from the management station. The default
is public and allows all requests.
Set Community Enter the Set community, which is the password for incoming Set
requests from the management station. The default is public and
allows all requests.
TrapCommunity Type the trap community, which is the password sent with each trap
to the SNMP manager. The default is public and allows all requests.
TrapDestination Type the IP address of the station to send your SNMP traps to.
To Next Page
Loading...
