Chapter 18 Universal Plug-and-Play (UPnP)
P-792H v2 User’s Guide
237
18.2 The UPnP Screen
Use the following screen to configure the UPnP settings on your P-792H v2. Click
Advanced > UPnP to display the screen shown next.
See Section 18.1 on page 235 for more information.
Figure 110 Advanced > UPnP > General
The following table describes the fields in this screen.
18.3 Installing UPnP in Windows Example
This section shows how to install UPnP in Windows Me and Windows XP.
Installing UPnP in Windows Me
Follow the steps below to install the UPnP in Windows Me.
Table 76 Advanced > UPnP > General
LABEL DESCRIPTION
Active the Universal Plug
and Play (UPnP) Feature
Select this check box to activate UPnP. Be aware that anyone
could use a UPnP application to open the web configurator's
login screen without entering the P-792H v2's IP address
(although you must still enter the password to access the web
configurator).
Allow users to make
configuration changes
through UPnP
Select this check box to allow UPnP-enabled applications to
automatically configure the P-792H v2 so that they can
communicate through the P-792H v2, for example by using
NAT traversal, UPnP applications automatically reserve a NAT
forwarding port in order to communicate with another UPnP
enabled device; this eliminates the need to manually configure
port forwarding for the UPnP enabled application.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
