Chapter 26 LAN Setup
P-792H v2 User’s Guide
302
26.4 LAN IP Alias
Use menu 3.2 to configure the first network, and you use menu 3.2.1 to configure
the other two networks. Move the cursor to the Edit IP Alias field, press [SPACE
BAR] to choose Yes and press [ENTER] to configure the second and third network.
Figure 141 Menu 3.2.1: IP Alias Setup
Use the instructions in the following table to configure IP alias parameters.
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Table 113 Menu 3.2.1: IP Alias Setup
FIELD DESCRIPTION
IP Alias 1, 2 Choose Yes to configure the LAN network for the P-792H v2.
IP Address Enter the IP address of your P-792H v2 in dotted decimal notation.
IP Subnet
Mask
Your P-792H v2 will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing subnetting,
use the subnet mask computed by the P-792H v2.
RIP Direction Press [SPACE BAR] and then [ENTER] to select the RIP direction. Options
are
Both, In Only, Out Only or None.
Version Press [SPACE BAR] and then [ENTER] to select the RIP version. Options
are
RIP-1, RIP-2B or RIP-2M.
Incoming
protocol filters
Enter the filter set(s) you wish to apply to the incoming traffic between
this node and the P-792H v2.
Outgoing
protocol filters
Enter the filter set(s) you wish to apply to the outgoing traffic between
this node and the P-792H v2.
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to
Confirm…] to save your configuration, or press [ESC] at any time to cancel.
To Next Page
Loading...
