Chapter 13 Static Route
P-792H v2 User’s Guide
188
13.2 The Static Route Screen
Use this screen to view the static route rules. Click Advanced > Static Route to
open the Static Route screen.
Figure 86 Advanced > Static Route
The following table describes the labels in this screen.
Table 57 Advanced > Static Route
LABEL DESCRIPTION
# This is the number of an individual static route.
Active This field indicates whether the rule is active or not.
Clear the check box to disable the rule. Select the check box to enable it.
Name This is the name that describes or identifies this route.
Destination This parameter specifies the IP network address of the final destination.
Routing is always based on network number.
Gateway This is the IP address of the gateway. The gateway is a router or switch
on the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
Subnet Mask This parameter specifies the IP network subnet mask of the final
destination.
Modify Click the Edit icon to go to the screen where you can set up a static route
on the P-792H v2.
Click the Remove icon to remove a static route from the P-792H v2. A
window displays asking you to confirm that you want to delete the route.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
