Chapter 6 WAN Setup
P-792H v2 User’s Guide
68
6.3 The More Connections Screen
The P-792H v2 allows you to configure more than one Internet access connection.
To configure additional Internet access connections click Network > WAN >
More Connections. The screen differs by the encapsulation you select. When you
use the WAN > Internet Access Setup screen to set up Internet access, you are
configuring the first WAN connection.
Figure 26 Network > WAN > More Connections
Protocol Filter Select the protocol filter(s) to control incoming traffic. You may choose
up to 4 sets of filters.
You can configure packet filters in the Packet Filter screen. See
Chapter 12 on page 217 for more details.
Generic Filter Select the generic filter(s) to control incoming traffic. You may choose
up to 4 sets of filters.
You can configure generic filters in the Packet Filter screen. See
Chapter 12 on page 217 for more details.
Outgoing Filter
Sets
Protocol Filter Select the protocol filter(s) to control outgoing traffic. You may choose
up to 4 sets of filters.
You can configure protocol filters in the Packet Filter screen. See
Chapter 12 on page 217 for more details.
Generic Filter Select the generic filter(s) to control outgoing traffic. You may choose
up to 4 sets of filters.
You can configure generic filters in the Packet Filter screen. See
Chapter 12 on page 217 for more details.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Table 13 Network > WAN > Internet Access Setup: Advanced Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
