Chapter 30 NAT Setup
P-792H v2 User’s Guide
323
3 Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes and
then press [ENTER] to bring up Menu 11.3 - Remote Node Network Layer
Options.
Figure 154 Menu 11.3: Applying NAT to the Remote Node
The following table describes the fields in this menu.
30.2 NAT Setup
Use the address mapping sets menus and submenus to create the mapping table
used to assign global addresses to computers on the LAN and the DMZ. Set 255 is
used for SUA. When you select Full Feature in menu 4 or menu 11.3, the SMT will
use the address mapping set that you specify. When you select SUA Only, the SMT
will use the pre-configured Set 255 (read only).
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment = Static Ethernet Addr Timeout(min)= N/A
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= None
IP Policies=
Table 122 Applying NAT in Menus 4 & 11.3
FIELD DESCRIPTION OPTIONS
Network
Address
Translation
When you select this option the SMT will use the specified
address mapping set (menu 15.1 - see Section 30.2.1 on page
324 for further discussion). You can configure any of the
mapping types described in Chapter 8 on page 101. Choose Full
Feature if you have multiple public WAN IP addresses for your
P-792H v2.
When you select Full Feature you must configure at least one
address mapping set.
Full
Feature
NAT is disabled when you select this option. None
When you select this option the SMT will use Address Mapping
Set 255 (menu 15.1 - see Section 30.2.1 on page 324). Choose
SUA Only if you have just one public WAN IP address for your P-
792H v2.
SUA Only
To Next Page
Loading...
