Chapter 6 WAN Setup
P-792H v2 User’s Guide
73
6.3.2 Configuring More Connections Advanced Setup
Use this screen to edit your P-792H v2's advanced WAN settings. Click the
Advanced Setup button in the More Connections Edit screen. The screen
appears as shown.
Figure 28 Network > WAN > More Connections: Edit: Advanced Setup
The following table describes the labels in this screen.
Table 16 Network > WAN > More Connections: Edit: Advanced Setup
LABEL DESCRIPTION
RIP & Multicast Setup This section is not available when you configure the P-792H v2 to
be in bridge mode.
RIP Direction Select the RIP direction from None, Both, In Only and Out
Only.
RIP Version Select the RIP version from RIP-1, RIP-2B and RIP-2M.
Multicast IGMP (Internet Group Multicast Protocol) is a network-layer
protocol used to establish membership in a multicast group. The
P-792H v2 supports IGMP-v1, IGMP-v2 and IGMP-v3. Select
None to disable it.
ATM QoS
ATM QoS Type Select CBR (Continuous Bit Rate) to specify fixed (always-on)
bandwidth for voice or data traffic. Select UBR (Unspecified Bit
Rate) for applications that are non-time sensitive, such as e-mail.
Select VBR-nRT (Variable Bit Rate-non Real Time) or VBR-RT
(Variable Bit Rate-Real Time) for bursty traffic and bandwidth
sharing with other applications.
To Next Page
Loading...
