ZyXEL Communications P-792H - Example Xmodem Configuration Upload Using Hyperterminal

Chapter 35 Firmware and Configuration File Maintenance
P-792H v2 User’s Guide
384
2 After the "Starting Xmodem upload" message appears, activate the Xmodem
protocol on your computer. Follow the procedure as shown previously for the
HyperTerminal program. The procedure for other serial communications programs
should be similar.
3 Enter “atgo” to restart the P-792H v2.
35.5.11 Example Xmodem Configuration Upload Using
HyperTerminal
Click Transfer, then Send File to display the following screen.
Figure 216 Example Xmodem Upload
After the configuration upload process has completed, restart the P-792H v2 by
entering “atgo”.