Chapter 28 Remote Node Setup
P-792H v2 User’s Guide
309
Authen This field appears if you select PPPoE in the Encapsulation field.
Select what type of authentication your ISP uses. Select CHAP/PAP
if you want the P-792H v2 to support both choices.
Route Press [SPACE BAR] and then [ENTER] to select IP to enable IP-
based routing to this remote node. This is not effective unless you
enable IP-based routing in the P-792H v2 too. See Menu 1: General
Setup in Section 24.1 on page 291.
You should enable Route IP, Bridge, or both in this screen. If you
disable Route IP and Bridge, the device does not send traffic
between the LAN ports and remote node.
Bridge If Route is IP, select Yes in this field to enable bridging to this
remote node for protocols that are not supported by IP-based
routing (for example, SNA).
If Route is None, select Yes in this field to enable bridging to this
remote node for all protocols.
In either case, this setting is not effective unless you enable bridging
in the P-792H v2 too. See Menu 1: General Setup in Section 24.1 on
page 291.
You should enable Route IP, Bridge, or both in this screen. If you
disable Route IP and Bridge, the device does not send traffic
between the LAN ports and remote node.
Edit IP/Bridge This field is enabled if Route is IP. If you want to set up the WAN IP
address and advanced features for the WAN port, press [SPACE BAR]
to select Yes and press [ENTER]. Menu 11.3 appears.
Edit ATM/PTM
Options
This field is enabled if Route is IP. Press [SPACE BAR] to select Yes
and press [ENTER] to edit the virtual channel and ATM QoS settings.
Menu 11.6 appears.
Edit Advance
Options
This field is displayed if you are editing remote node 1, and it is only
enabled for PPPoE connections. If you want to set up advanced
features for the Internet connection, press [SPACE BAR] to select
Yes and press [ENTER]. Menu 11.8 appears.
Telco Option This section is only enabled for PPPoA or PPPoE connections.
Allocated
Budget(min)
Enter the maximum amount of time (in minutes) each call can last.
Enter 0 if there is no limit. With Period, you can set a limit on the
total outgoing call time of the P-792H v2 within a certain period of
time. When the total outgoing call time exceeds the limit, the current
call will be dropped and any future outgoing calls will be blocked.
Period(hr) Enter how often (in hours) the Allocated Budget is reset. For
example, if you can call for thirty minutes every hour, set the
Allocated Budget to 30, and set this field to 1.
Schedule Sets Enter the schedule sets that apply to this connection.
Nailed-Up
Connection
Select this if you want the P-792H v2 to automatically connect to
your ISP when it is turned on and to remain connected all the time.
This is not recommended if you pay for your Internet connected
based on the amount of time you are connected.
Session Options
Table 115 Menu 11.1: Remote Node Profile (nodes 1-7) (continued)
FIELD DESCRIPTION
To Next Page
Loading...
