ZyXEL Communications P-792H - Page 325

Chapter 30 NAT Setup
P-792H v2 User’s Guide
325
30.2.1.1 User-Defined Address Mapping Sets
Note: The entire set will be deleted if you leave the Set Name field blank and press
[ENTER] at the bottom of the screen.
Figure 157 Menu 15.1.1: Address Mapping Rules
Note: The Type, Local and Global Start/End IPs are configured in menu 15.1.1.1
(described later) and the values are displayed here.
Menu 15.1.1 - Address Mapping Rules
Set Name= ACL Default Set
Idx Local Start IP Local End IP Global Start IP Global End IP Type
--- --------------- --------------- --------------- --------------- --
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Action= None Select Rule= N/A
Table 123 Menu 15.1.1: Address Mapping Rules
FIELD DESCRIPTION
Set Name This is the name of the set you selected in menu 15.1 or enter the name of
a new set you want to create.
Idx This is the index or rule number.
Local Start
IP
Local Start IP is the starting local IP address (ILA).
Local End IP Local End IP is the ending local IP address (ILA). If the rule is for all local
IPs, then the start IP is 0.0.0.0 and the end IP is 255.255.255.255.
Global Start
IP
This is the starting global IP address (IGA). If you have a dynamic IP, enter
0.0.0.0 as the Global Start IP.
Global End
IP
This is the ending global IP address (IGA).
Type These are the mapping types discussed above. Server allows us to specify
multiple servers of different types behind NAT to this machine. See later
for some examples.
Once you have finished configuring a rule in this menu, press [ENTER] at the message
“Press ENTER to Confirm…” to save your configuration, or press [ESC] to cancel.