Chapter 12 VPN
P-792H v2 User’s Guide
159
Remote
Address
This is the IP address(es) of computer(s) on the remote network behind
the remote IPSec router.
This field displays N/A when the Secure Gateway Address field
displays 0.0.0.0. In this case only the remote IPSec router can initiate
the VPN.
The same (static) IP address is displayed twice when the Remote
Address Type field in the VPN Setup - Edit screen is configured to
Single.
The beginning and ending (static) IP addresses, in a range of computers
are displayed when the Remote Address Type field in the VPN Setup -
Edit screen is configured to Range.
A (static) IP address and a subnet mask are displayed when the Remote
Address Type field in the VPN Setup - Edit screen is configured to
Subnet.
Encap. This field displays Tunnel or Transport mode (Tunnel is the default
selection).
IPSec
Algorithm
This field displays the security protocols used for an SA.
Both AH and ESP increase P-792H v2 processing requirements and
communications latency (delay).
Secure
Gateway IP
This is the static WAN IP address or URL of the remote IPSec router. This
field displays 0.0.0.0 when you configure the Secure Gateway Address
field in the VPN-IKE screen to 0.0.0.0.
Modify Click the Edit icon to go to the screen where you can edit the VPN
configuration.
Click the Remove icon to remove an existing VPN configuration.
Apply Click this to save your changes and apply them to the P-792H v2.
Cancel Click this return your settings to their last saved values.
Table 43 Security > VPN > Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
