EasyManua.ls Logo

ZyXEL Communications P-792H - Page 211

ZyXEL Communications P-792H
472 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 15 Quality of Service (QoS)
P-792H v2 User’s Guide
211
See Appendix F on page 455 for a list of commonly-used services. The following
table describes the labels in this screen.
Table 64 Advanced > QoS > Class Setup: Edit
LABEL DESCRIPTION
Class Configuration
Active Select the check box to enable this classifier.
Name The text may consist of up to 20 letters, numerals and any printable
character found on a typical English language keyboard.
Interface Select from which interface traffic of this class should come.
Priority Select a priority level (between 0 and 7) or select Auto to have the P-
792H v2 map the matched traffic to a queue according to the internal
QoS mapping table. See Section 15.6.4 on page 216 for more
information.
"0" is the lowest priority level and "7" is the highest.
Routing Policy Select the next hop to which traffic of this class should be forwarded.
Select By Routing Table to have the P-792H v2 use the routing table
to find a next hop and forward the matched packets automatically.
Select To WAN Index to route the matched packets through the
specified PVC. This option is available only when the WAN type is
ADSL.
Select To Gateway Address to route the matched packets to the
router or switch you specified in the Gateway Address field.
WAN Index Select a PVC index number.
Gateway
Address
Enter the IP address of the gateway, which should be a router or
switch on the same segment as the P-792H v2’s interface(s), that can
forward the packet to the destination.
Order This shows the ordering number of this classifier. Select an existing
number for where you want to put this classifier and click Apply to
move the classifier to the number you selected. For example, if you
select 2, the classifier you are moving becomes number 2 and the
previous classifier 2 gets pushed down one.
Tag Configuration
DSCP Value Select Same to keep the DSCP fields in the packets.
Select Auto to map the DSCP value to 802.1 priority level
automatically.
Select Mark to set the DSCP field with the value you configure in the
field provided.

Table of Contents

Other manuals for ZyXEL Communications P-792H

Related product manuals