ZyXEL Communications P-792H - Page 249

Chapter 19 System Settings
P-792H v2 User’s Guide
249
The following table describes the labels in this screen.
Table 77 Maintenance > System > General
LABEL DESCRIPTION
System Setup
System Name Choose a descriptive name for identification purposes. It is
recommended you enter your computer’s “Computer name” in this field.
This name can be up to 30 alphanumeric characters long. Spaces are not
allowed, but dashes “-” and underscores "_" are accepted.
Domain Name Enter the domain name (if you know it) here. If you leave this field blank,
the ISP may assign a domain name via DHCP.
The domain name entered by you is given priority over the ISP assigned
domain name.
The Domain Name entry is propagated to the DHCP clients on the LAN.
Administrator
Inactivity
Timer
Type how many minutes a management session (either via the web
configurator or telnet) can be left idle before the session times out. The
default is 5 minutes. After it times out you have to log in with your
password again. Very long idle timeouts may have security risks. A value
of "0" means a management session never times out, no matter how
long it has been left idle (not recommended).
Password
User Password
New
Password
Type your new user password (up to 30 characters). Note that as you
type a password, the screen displays a (*) for each character you type.
After you change the password, use the new password to access the P-
792H v2.
Retype to
confirm
Type the new password again for confirmation.
Admin
Password
Old
Password
Type the default password or the existing password you use to access the
system in this field.
New
Password
Type your new system password (up to 30 characters). Note that as you
type a password, the screen displays a (*) for each character you type.
After you change the password, use the new password to access the P-
792H v2.
Retype to
confirm
Type the new password again for confirmation.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.