Chapter 2 Introducing the Web Configurator
P-792H v2 User’s Guide
33
LAN IP Use this screen to configure LAN TCP/IP settings and
other advanced properties.
DHCP Setup Use this screen to configure LAN DHCP settings.
Client List Use this screen to view current DHCP client information
and to always assign specific IP addresses to individual
MAC addresses (and host names).
IP Alias
Use this screen to partition your LAN interface into
subnets.
NAT General Use this screen to enable NAT.
Port Forwarding
Use this screen to make your local servers visible to
the outside world.
This screen appears when you choose SUA Only from
the NAT > General screen.
Address
Mapping
Use this screen to configure network address
translation mapping rules.
This screen appears when you choose Full Feature
from the NAT > General screen.
ALG Use this screen to enable or disable SIP ALG.
Security
Firewall General Use this screen to activate/deactivate the firewall and
the default action to take on network traffic going in
specific directions.
Rules This screen shows a summary of the firewall rules, and
allows you to edit/add a firewall rule.
Threshold Use this screen to configure the thresholds for
determining when to drop sessions that do not become
fully established.
Content Filter Keyword Use this screen to block access to web sites containing
certain keywords in the URL.
Schedule Use this screen to set the days and times for the P-
792H v2 to perform content filtering.
Trusted Use this screen to exclude a range of users on the LAN
from content filtering on your P-792H v2.
Packet Filter Packet Filter Use this screen to configure the rules for protocol and
generic filter sets.
VPN Setup Use this screen to configure each VPN tunnel.
Monitor Use this screen to look at the current status of each
VPN tunnel.
VPN Global
Setting
Use this screen to allow NetBIOS traffic through VPN
tunnels.
Certificates Trusted CAs Use this screen to import CA certificates to the P-792H
v2.
Advanced
Table 3 Navigation Panel Summary
LINK TAB FUNCTION