ZyXEL Communications P-792H - Page 389

Chapter 36 Menus 24.8 to 24.11
P-792H v2 User’s Guide
389
Enter 10 to go to Menu 24.10 - System Maintenance - Time and Date
Setting to update the time and date settings of your P-792H v2 as shown in the
following screen.
Figure 222 Menu 24.10: System Maintenance - Time and Date Setting
The following table describes the fields in this screen.
Menu 24.10 - System Maintenance - Time and Date Setting
Time Protocol= None
Time Server Address= N/A
Current Time: 06 : 43 : 17
New Time (hh:mm:ss): 06 : 43 : 00
Current Date: 2000 - 01 - 01
New Date (yyyy-mm-dd): 2000 - 01 - 01
Time Zone= (GMT+0100) Brussels, Copenhagen, Madrid, Paris
Daylight Saving= No
Start Date (mm-nth-week-hr): Jan. - 1st - Sun.(02) - 00
End Date (mm-nth-week-hr): Jan. - 1st - Sun.(02) - 00
Table 139 Menu 24.10: System Maintenance - Time and Date Setting
FIELD DESCRIPTION
Time Protocol Enter the time service protocol that your timeserver uses. Not all time
servers support all protocols, so you may have to check with your ISP/
network administrator or use trial and error to find a protocol that
works. The main differences between them are the format.
Daytime (RFC 867) format is day/month/year/time zone of the server.
Time (RFC-868) format displays a 4-byte integer giving the total
number of seconds since 1970/1/1 at 0:0:0.
The default, NTP (RFC-1305), is similar to Time (RFC-868).
Select None to enter the new time and new date manually.
Time Server
Address
Enter the IP address or domain name of your timeserver. Check with
your ISP/network administrator if you are unsure of this information.
The default is tick.stdtime.gov.tw
Current Time This field displays an updated time only when you reenter this menu.
New Time
(hh:mm:ss)
Enter the new time in hour, minute and second format. This field is
available when you select None in the Time Protocol field.
Current Date This field displays an updated date only when you reenter this menu.
New Date
(yyyy-mm-dd)
Enter the new date in year, month and day format. This field is available
when you select None in the Time Protocol field.
Time Zone Press [SPACE BAR] and then [ENTER] to set the time difference between
your time zone and Greenwich Mean Time (GMT).