Chapter 6 WAN Setup
P-792H v2 User’s Guide
64
Tag VLAN ID for
egree packets
Select this option to add the VLAN tag (specified below) to the
outgoing traffic through this connection.
This is available only when you select PTM in the Transfer Mode
field.
Enter 802.1P
Priority
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag
into a MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic
through this connection. The greater the number, the higher the
priority level.
Enter 802.1Q
VLAN ID
Type the VLAN ID number (from 1 to 4094) for traffic through this
connection.
Line Select the DSL line you want the P-792H v2 to use as a default for
outgoing traffic (remote node 1).
IP Address This option is available if you select Routing in the Mode field.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP
address is not fixed; the ISP assigns you a different one each time you
connect to the Internet.
Select Obtain an IP Address Automatically if you have a dynamic
IP address; otherwise select Static IP Address and type your ISP
assigned IP address in the IP Address field below.
Subnet Mask This option is available if you select ENET ENCAP in the
Encapsulation field.
Enter a subnet mask in dotted decimal notation.
Gateway IP
address
This option is available if you select ENET ENCAP in the
Encapsulation field.
Specify a gateway IP address (supplied by your ISP).
DNS Server
First DNS Server
Second DNS
Server
Third DNS Server
Select Obtained From ISP if your ISP dynamically assigns DNS
server information (and the P-792H v2's WAN IP address) and you
select Obtain an IP Address Automatically.
Select User-Defined if you have the IP address of a DNS server.
Enter the DNS server's IP address in the field to the right. If you chose
User-Defined, but leave the IP address set to 0.0.0.0, User-
Defined changes to None after you click Apply. If you set a second
choice to User-Defined, and enter the same IP address, the second
User-Defined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. You must
have another DNS server on your LAN, or else the computers must
have their DNS server addresses manually configured. If you do not
configure a DNS server, you must know the IP address of a computer
in order to access it.
Connection (PPPoA and PPPoE encapsulation only)
Nailed-Up
Connection
Select Nailed-Up Connection when you want your connection up all
the time. The P-792H v2 will try to bring up the connection
automatically if it is disconnected.
Table 12 Network > WAN > Internet Access Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
