1-5
Table 1-1 display ftm information command output description
Field Description
FTM State
FTM State:
z DISC STATE: In the topology discovery state.
z LISTEN STATE: In the topology discovery
state, and the FTM slave device is listening.
z HB STATE: The fabric operates normally.
Unit ID
Unit ID:
z FTM-Master
z FTM-Slave
Fabric Type
Fabric topology structure:
z Line
z Ring
Fabric Auth
Authentication mode for an XRN fabric
You can use the xrn-fabric
authentication-mode command to configure
the authentication mode and password for an
XRN fabric.
Fabric Vlan ID
ID of the VLAN transmitting fabric
synchronization information.
You can use the ftm fabric-vlan command to
specify the VLAN used to form an XRN fabric.
Left Port
Right Port
Status of the two fabric ports on a device:
z Link-Down
z Isolated (temporary): The fabric is not in a
normal state yet, and the fabric port is
isolated temporarily.
z Isolated (reached max units)
z Isolated (different system name): The fabric
name of the device directly connected to the
switch and the existing fabric name of the
fabric are different.
z Isolated (different version): The software
version of the directly connected device and
that of the current device are different.
z Isolated (auth failure): The XRN fabric
authentication modes configured for the local
device and that of the fabric are not the same,
or the password configured does not match.
z Isolated (connection error): Fabric port
connection error occurs.
z Disable: Fabric is disabled on the port.
z Normal
Refer to the Operation Manual for the status and
solution of the problems.
To Next Page
Loading...
