Configuration
198
Aastra 470 ab R3.0
syd-0337/1.5 – R3.0 – 05.2013
5. 4. 2 Function code for remote access
Tab. 87 Function codes for remote access authorization
When remote access is enabled using function code *754, access will automatically
be barred again once the remote configuration process has been completed. It is
possible to bar access manually using #754 before a remote configuration process
has been initiated.
Remote access can be enabled permanently using the function code *753. To bar
access, the authorized user must enter the function code #753 manually.
The enabling or barring of remote access authorization using the function code is
signalled in each case by an acknowledgement tone.
Remote access authorization can also be enabled or barred in the AMS Configura-
tion Manager or with the System Assistant function on the Office 45, if the relevant
authorization has been given.
Note:
In a QSIG network it is important to make sure that the authorization to
change the remote access is also denied to unauthorized PISN users. Oth-
erwise a PISN user would be able to use an abbreviated dialling number
defined for the destination PINX and containing the appropriate function
code to change the remote access authorization to the destination PINX.
Aastra Intelligent Net:
In an AIN the remote access of all the nodes depends on the setting in the
Master. If remote access is enabled in the Master, both the AIN configura-
tion and the offline configuration of the satellites are enabled.
Remote access via an external dial-up connection to the AIN is also pro-
tected and has to be explicitly enabled via the control panel on the front
panel. This is irrespective of whether dial-up access is via a satellite or
directly to the Master.
Enable / bar a one-off remote access *754 / #754
Enable/bar a permanent remote access *753 / #753
To Next Page
Loading...
Need help?
General