Operation and Maintenance
224
Aastra 470 ab R3.0
syd-0337/1.5 – R3.0 – 05.2013
6. 3. 3. 2 New card with fewer ports
A card is replaced by a similar card with fewer ports.
Procedure:
Change the card and put the system into operation again. Similar procedure as de-
scribed in "Replacing a defective interface card", page 223.
The following data is deleted:
• The system and terminal configuration data of the terminals on the terminalin-
terfaces that are no longer present in the new configuration.
• The system configuration data of the network interfaces that are no longer pres-
ent in the new configuration.
Tab. 92 Example: Reducing the number of terminal or network interfaces
Note:
If the terminal configuration data of system phones is deleted following
the reconfiguration of a card, a warning message will appear beforehand
to give you the possibility of cancelling the process. However, this is pos-
sible only if the configuration data of the original card was not already
deleted beforehand.
16DSI 8DSI The configuration data of terminal interfaces 9...16 are deleted.
8BRI 4BRI The configuration data of network interfaces 5...8 are deleted.
To Next Page
Loading...
