Expansion Stages and System Capacity
78
Aastra 470 ab R3.0
syd-0337/1.5 – R3.0 – 05.2013
• G.729 Codec
This licence allows the use of a G.729 codec for the voice channel of Aastra SIP
phones, IP system phones and SIP network interfaces (also for SIP networking).
The licences are always used wherever they are required. Aastra SIP-DECT® and
standard SIP terminals do not require this licence. Likewise, calls to the emer-
gency number do not require a licence.
Note
If several emergency destinations are defined in a system, the follow-
ing points need to be considered:
– Sufficient G.729 Codec licences must be available.
– No phone and no SIP network interface is configured exclusively to
G.729 Codec.
• Licences for the fax service on the CPU2
The CPU2 applications card of an Aastra 470 communication server contains
software with a server-based fax solution. Use of this fax service is licensed as fol-
lows:
– Aastra 400 Embedded Fax Base
This licence comprises 2 Aastra 400 Embedded Fax Channels and 10 licences
Aastra 400 Embedded Fax Clients. This means that 2 fax messages can be sent
or received simultaneously and 10 users can be assigned a fax mailbox.
– Aastra 400 Embedded Fax Channels
Additional media channels for simultaneously transmitting and receiving fax
messages (maximum number = 8 media channels).
– Aastra 400 Embedded Fax Clients
Additional users configurable with fax mailbox.
• BluStar licences
– BluStar Softphones for Aastra 400
This is a BluStar client licence. One licence per client is required to operate
BluStar softphones. The licences are needed to register the clients on the sys-
tem.
– BluStar Softphone Video Options for Aastra 400
This licence is required for using the video functionality of a BluStar soft-
phone. A BluStar client licence must be in place.
– BluStar MS Lync Plugin for Aastra 400 and BluStar IBM Sametime Plugin for
Aastra 400
These plug-in licences are a BluStar client to be connected to an MS Lync
server or IBM Sametime server and are required in addition to a BluStar client
licence. Only one plug-in can be used in each case per client.